BILLYGOAT BRUSHCUTTER

				BILLYGOAT BRUSHCUTTER Say good-bye to sickle mowers, hand held cutters, chainsaws, etc. Designed for abuse, the Outback® Brush Cutter cuts a clear path through the densest brush, grass and weeds over 8 feet tall, saplings up to 1.5 inches in diameter, and other problem vegetation at the rate of 2/3 acre per hour. If the front brush card can push if over, the Outback Brush® Cutter will cut it.

Video


CARLTON 1790 CHIPPER

				CARLTON 1790 CHIPPER The Carlton 1790 chipper is built to withstand the punishment you dish out. From the heavy duty infeeders to the formed infeed, the Carlton 1790 is the most solidly constructed chipper on the market today.

Video

Product Specifications Link

STIHL POLE SAW

				STIHL POLE SAW Do not let cutting those tough branches get the best of you. For those hard-to-get to trees, the HT 101 STIHL telescoping pole pruner will take you there. Powered by a low-emission engine, its shaft adjusts from 7 ft. 6 in. to 11 ft. 6 in. — allowing professionals to reach branches up to 16 feet above the ground.

Video

Product Specifications Link

HEDGE TRIMMERS

				HEDGE TRIMMERS Hedges can be decorative or practical, but when it comes to their appearance you want the best looking shrubs and trees possible. If you want hedges that are trimmed precisely, with smooth, clean lines, our hedge trimmers deliver power with a variety of blade degrees to get the job done fast. Get a new STIHL hedge trimmer and get going on your next trimming project.

  Product Specifications Link

Barreto Stump Grinder SG-30

				Barreto Stump Grinder SG-30 DESIGN An offshoot of the dependable TK track trencher, the 30SG stump grinder features a variant of the same time-tested track drive platform used by the TK series. The 30SG has a hydraulically-driven cutter wheel that is raised and lowered into the stump and then moved from side to side to cut down. The 30SG power options consist of a 31hp Briggs and Stratton Vanguard V-Twin or a 26.5hp Kohler EFI engine. The engine is coupled to two gear pumps: the larger gear pump drives the cutter wheel and the smaller pump works the tilt and swing cylinders. The tracks are driven by independent hydrostatic pumps mounted on the rear of the engine for easy access and simple linkage control. Counterbalance valves on each track drive prevent the track motors from slipping while the cutter wheel is engaged in the cutting process, even while operating on a slope. CONTROLS The cutter wheel operation and articulating arm are operated by controls mounted on the console. The cutter wheel is activated by a switch on the control stick and has a secondary safety switch to prevent accidental engagement. Back and forth movement across the stump, as well as depth of cut, are easily controlled by handles on the console, allowing for carefully controlled movement of the cutter wheel as it reduces the stump to chips. ROI All hydraulic drive to the cutter wheel eliminates costly belts. It also increases customer satisfaction by ensuring there is no loss of power because of a damaged belt or mechanical component. The track drive increases maneuverability around the job site, creating customer satisfaction by allowing them to get the job done with increased efficiency.

Video

Product Specifications Link


Copyright